Step by step directions to gluing inner corners
When finishing, the principal problem can be irregular walls as well as the resulting springs on the wallpaper. It’s also essential to take into account that as soon as the walls are crooked, the joints of wallpaper canvases can invisibly.
After gluing the last one in the front of the interior corner of the cloth should measure the remaining distance. It’s measured from the edge of the glued cloth to the adjoining wall, the resulting amount is added 10-15 millimeters. When the walls are very curved, the further figure could be more.
Cut a strip equal to the resulting figure, taking into account the allowance. The surfaces have been treated with glue. Depending on the type of coating it might be precisely the wall or surfaces.
The strip is then glued independently with the cut gidpola.ru side to the wall. The wallpaper should go on the other airplane.
If the glued background is wrinkled, you need to make several modest cuts perpendicular to the springs.
Level or slope on the adjacent wall is a vertical lineup. The distance from the corner is equivalent to the diameter of the prior cut strip, never including additions.
The surfaces have been smeared with glue, and then the coat is glued into the wall using the flat side towards the line. The cut side goes on the adjacent wall.
The best way to glue the outer corner (outer corner)?
Protruding corner ought to be pasted by analogy with the inner, however there are little gaps, which also have to be taken into account when working.
Measured the space remaining from the glued background into the adjoining wall. Insert 20-25 millimeters to the figure.
A section is cut away, taking into account the added 20-25 millimeters.
Prior to gluing, the surfaces are treated with glue.
The edge has to be glued to the wallpaper already fixed on the wall, your own cut “extends” to the adjoining plane. If necessary, small cuts are made in the place of going to another background, smoothed and pushed to the wall.
Draw a vertical strip onto the adjacent wall at a distance of only glued cut strip and 6-10 millimeters.
After applying the adhesive, the strip is then put on the wall using its flat side to the marked line, moving over the border of the glued strip.
The joints are smeared with adhesive and ironed using a rollercoaster. Following that, the top layer is trimmed along the ruler and the 2 layers are combined together.